| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-11
5-71. .BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-ASSEMBLY(Cont)
NOTE
A step under the shoulder of the installer will
position the oil seal approximately .005" below the
finished face of the end plate. This is within the
.002" to .008" specified.
4. Install remaining oil
seal s in end plates
in the same manner
c.
Blower
1. The top of the end
front
plate is identified
end
by three bolt holes
plate
and one oil hole.
(47)
The bottom side of
the end plate has
three bolt holes and
three oil holes.
The dowel pins (57)
extend on both sides
of front end plate.
CAUTION
The horizontal oil passage in the top front face of
the front end plate that intersects the vertical oil
passage is plugged. Do not install this end plate on
the rear end, of the blower housing (50).
2. Attach front end
plate to the front
end of blower housing
first. Attach rear
end plate to the
blower housing after
rotors are in place.
Then, attach the
front endplate to
blower housing.
5-992
|
||
|
||
