| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-11
5-113. FLANKING RUDDER LIMIT SWITCH - MAINTENANCE INSTRUCTIONS
(Continued).
LOCATION
ITEM
ACTION
REMARKS
ALIGNMENT (Cont)
Limit switches will not be in circuit, and care should be exercised when
approaching hard-over rudder.
1. SW1
-
position rudder to 400 left.
Set cam to open SW1 (between
terminals 2 and 3) at 400 left.
NOTE
Move cam in same direction that it would travel in going from midships to hard-
over position.
2. SW6
-
Position rudder to 40right.
Set cam to open SW6 (between
terminals 17 and 18).
3. SW3
-
Position rudder to 1right.
Set cam to close (between
terminals 7 and 8) as cam is
rotated in direction it would
move from midships to 1right.
4. SW4 - Position rudder to 1left.
Set cam to close (between
terminals 10 and 11) as cam
is rotated in direction it
would move from midships to
1left.
5. SW5 - Position rudder to 20 right.
Set cam to close (between
terminals 14 and 15) as cam
is rotated from hard right
back towards 2right rudder.
6. SW2 - Position rudder to 20 left.
Set cam to close (between
terminals 5 and 6) as cam is
rotated from hard left back
towards 2left rudder.
5-1283
|
||
|
||
