TM 55-1905-219-14-3
Table 3-61. Anchor Winch Engine Abnormal Engine
Operation Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
Detonation (Cont).
b. Inspect the blower oil seals by removing the air
inlet housing and watching through the blower
inlet for oil radiating away from the blower
rotor shaft oil seals while the engine is run-
ning. If oil is passing through the seals,
Refer to Direct Support Maintenance.
c. Check for a defective blower-to-block gasket.
Replace the gasket, if necessary.
Step 2.
Check for low coolant temperature.
Refer to MALFUNCTION 1.
Step 3.
Check for faulty injectors.
a. Check injector timing and the position of each
injector rack. Refer to paragraph 3-147 and
3-161.
b. The erratic operation may be caused by an injector
check valve leaking, spray tip holes
enlarged or a broken spray tip. Replace faulty
injectors. Refer to paragraph 3-147.
3-192