| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-4
3-9.5. LUBRICATING OIL PRESSURE SWITCH - MAINTENANCE INSTRUCTIONS.
a. The lubricating oil pressure switch is of the "break" type. The lubricating oil pressure switch is
2
calibrated to break contac4 when the lubricating oil pressure increases to 10 psi (7.03 gm cm). The
phrase "10-BREAK" is stamped on the switch cover.
b. As the lubricating oil pressure increases when the engine starts, the diaphragm in the switch body
expands and forces the plunger upwards. Since the bottom of the adjusting screw bears against the
plunger and the adjusting screw is attached to the bracket which controls the upper breaker point arm,
2
the arm is also forced upwards. When the lubricating oil pressure increases to 10 psi (7.03 gm cm ),
2
the points separate. If the lubricating oil pressure decreases to 10 psi (7.03 gm cm ) during operation,
the breaker point will close and the alarm will sound.
NOTE
An alarm will sound in the Pilothouse.
This task covers:
a.
Testing
c.
Removal
b.
Adjustment
d.
Installation
INITIAL SETUP
Test Equipment
References
NONE
NONE
Equipment
Special Tools
Condition
Condition Description
NONE
NONE
Material/Parts
Special Environmental Conditions
NONE
NONE
Personnel Required
General Safety Instructions
2
NONE
LOCATION
ITEM
ACTION
REMARKS
Testing
1. Engine
Instrument
Start the engine and
panel
operate at idle speed.
3-404
|
||
|
||
