| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-4
3-34. CYLINDER HEAD - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
REMOVAL (Cont)
b. Water
Remove.
Refer to para-
mani-
fold
11. Injector
Injector
Remove.
Remove as an
control
control
assembly.
tube and
tube and
Refer to para-
brackets
brackets
NOTE
If the cylinder head is to be disassembled for reconditioning of the exhaust
valves and valve seat inserts or for a complete overhaul, remove fuel pipes and
injectors at this time. See paragraph 3-15 for removal of the injectors.
NOTE
Check the torque on the cylinder head bolts and stud nuts (if used) before
removing the head. Then remove the bolts and nuts and lift the cylinder head
from the cylinder block. If interference is encountered between the rear end of
the right-bank cylinder head and any of the flywheel attaching bolts, loosen the
bolts. Checking the torque before removing the head bolts and examining the
condition of the compression gaskets and seals after the head is removed may
reveal the causes of any cylinder head problems.
When placing the cylinder head assembly on a bench, protect the cam
followers and injector spray tips, if the injectors were not removed, by resting
the valve side of the head on 2 inch (5.08 cm) wood blocks.
3-748
|
||
|
||
