| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-4
3-40.4.
CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
g. Connec-
1. Remove.
ting rod
cap and
2. Push piston down until
ring corn-
the compression rings
pressor
pass the cylinder
liner ports.
8. Cylinder
liner,
piston
and con-
necting
rod as-
sembly
NOTES
1. If any of the pistons and liners are already in the engine, use hold-down clamps to
retain the liners in place when the crankshaft is rotated.
2. Rotate the crankshaft until the connecting rod journal of the particular cylinder being
worked on is at the bottom of its travel. Wipe the journal clean and lubricate it with
clean engine
a. Upper
Install in connecting rod
The upper bear-
bearing
(2). Lubricate.
ing shell does
shell
not have a con-
(1)
tinuous oil
groove. Lubri-
cate the bear-
ing shell with
clean engine
oil.
NOTE
Each connecting rod and its cap is numbered on one side - 1L, IR, 2L, 2R, etc.
These numbers and letters identify the caps with the rods and indicate the
particular cylinder in which they are used. Maintain these positions when
assembling the engine.
3-882
|
||
|
||
