APPENDIX B MAINTENANCE ALLOCATION CHART

Custom Search

APPENDIX A REFERENCES

TM-55-1905-219-14-4 Landing Craft Utility (LCU) 1667 Class Boston Hull Numbers 1667-1670 NSN 1905-00-168-5764 Manual

EXPLANATION OF COLUMNS IN SECTION II.

TM 55-1905-219-14-4

APPENDIX B

MAINTENANCE ALLOCATION CHART

SECTION I. INTRODUCTION

B-1.

GENERAL.

This section provides a general explanation of all maintenance and repair functions authorized at

various maintenance levels.

Section II designates overall responsibility for the performance of maintenance functions on the

identified end item or component and the work measurement time required to perform the functions by the

designated maintenance level. The implementation of the maintenance functions upon the end item or

components will be consistent with the assigned maintenance functions.

Section III lists the tools and test equipment required for each maintenance function as referenced

from Section II.

Section IV lists the remarks referenced from Section II.

B-2. EXPLANATION OF COLUMNS IN SECTION II.

Column (1), Group Number. Column 1 lists group numbers to identify related components,

assemblies, subassemblies, and modules with their next higher assembly. The applicable groups are listed in

the MAC in disassembly sequence beginning with the first group removed.

Column (2), Component/Assembly. This column contains the known names of components,

assemblies, subassemblies and modules for which maintenance is authorized.

Column (3), Maintenance Functions. This column lists the functions to be performed on the item

listed in Column 2. The maintenance functions are defined as follows:

(1)

Inspect. To determine serviceability of an item by comparing its physical, mechanical, or

electrical characteristics with established standards through examination.

(2)

Test. To verify serviceability and to detect incipient failure by measuring the mechanical or

electrical characteristics of an item and comparing those characteristics with prescribed standards.

(3)

Service. Operations required periodically to keep an item in proper operating condition, i.e., to

clean (decontaminate), to pre serve, to drain, to paint, or to replenish fuel, lubricants, hydraulic fluids, or

compressed air supplies.

B-1