| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-5
3-91.3. IDLER GEAR AND BEARING ASSEMBLY - MAINTENANCE
INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
4. Place second bearing
cone, numbered side
up, in idler gear and
bearing cup assembly
and against spacer
ring.
5. Then, position the
idler gear hub over
the bearing cones so
that the oil hole in
the hub is 1800 from
the gap in the spacer
ring.
b. Hub
Press the hub into the
idler gear bearing cones,
while rotating the gear
(to seat rollers properly
between cones) until the
face of the hub which
will be adjacent to the
cylinder block end plate
is flush with the corres-
ponding face of the bear-
ing cone. The bearing
cones should be supported
so as not to load the
bearing rollers during
this operation.
3-1578
|
||
|
||
