| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-5
3-92.1. FLYWHEEL - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSPECTION
2.
Check the contact face of
the flywheel for scoring,
over-heating or cracks.
If scored, the flywheel may
be refaced. However, do
not remove more than .020"
of metal from the flywheel.
Maintain all of the radii
when refacing the flywheel.
Although the flywheel sel-
dom requires replacement,
the flywheel ring gear may
become worn due to normal
usage or damaged by impro-
per use of the starting
motor to the extent that
it must be replaced. If
replacement of the ring
gear is necessary, refer
to Direct Support Mainte-
nance.
INSTALLATION
3.
a. Dowel
Check the extension.
The dowels must
pins (4)
not extend more
than 1/2 inch
(2.7 cm) from
the crankshaft.
b. Flywheel
1. Attach flywheel lift-
(3)
ing tool J 6361-01 to
the flywheel with two
7/16"-14 bolts. Then,
with the use of a
chain hoist,-position
the flywheel in the
flywheel housing and
over the dowels in the
crankshaft.
NOTE
Since one bolt hole is offset, the flywheel can be installed in only one position.
3-1606
|
||
|
||
