| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-5
3-94. LUBE OIL PUMP (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
CAUTION
Always check the clearance between the crankshaft gear and the oil pump idler
gear with the engine in the upright or running position.
If shims were used between the pump mounting feet and the bearing caps and new gears are not installed, the
same shims (cleaned) or the same number of new (identical) shims should be installed and the number then
adjusted to obtain the proper clearance between gear teeth. However, if new gears have been installed, a
larger number of shims will be required under the mounting feet. In either event, the pump must be tightened
on the bearing cap before the clearance between the gear teeth is measured.
3-1635
|
||
|
||
