| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-6
3-139.1. HYDRAULIC PUMP MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
k. Pocket
Trim the excess length
Use a pocket
seals
of each pocket seal
knife or razor
(33)
so that they are flush
blade.
and
with the edge of the
(34)
thrust plate.
l.
Drive
Insert in recess in
gear
shaft end cover.
(28)
m. Shaft
1. Put several drops
end
of oil, or cover
cover
to hold gasket.
(16),
and
2. Carefully line up
gasket
the ten holes.
(32)
This will avoid
tearing of the
screw holes.
n. Housing
1. Store both faces
It may be nec-
(30)
of housing and
essary to tap
air blow or wipe
the housing
clean.
lightly with a
soft hammer to
2. Press housing onto
make it fit
over the thrust
plate (31).
o. Driven
Insert into housing.
gear (29)
p. Port end
Store the face of the
cover
cover and air blow or
(22)
wipe clean.
q. Roller
Insert into cover.
Use an arbor
bearing
press.
(27)
3-2334
|
||
|
||
