| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-6
3-167.1. FLYWHEEL - MAINTENANCE INSTRUCTIONS.
a. The flywheel is attached to the rear end of the crankshaft with six self-locking bolts. Two dowels in
the end of the crankshaft aid in flywheel alignment and provide support when the flywheel bolts are removed.
A scuff plate is used between the flywheel and the bolt heads to prevent the bolt heads from scoring the
flywheel surface.
b. A steel ring gear, which meshes with the starting motor pinion, is shrunk onto the rim of the flywheel.
c. The flywheel is machined to provide true alignment with the torque converter.
d. The flywheel must be removed for service operations such as replacing the starter ring gear,
crankshaft or flywheel housing.
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP
Test Equipment
References
None
None
Equipment
Special Tools
Condition Condition Description
Paragraph
Lifting tool - J6361-01
Chain hoist
Torque wrench
Dial Indicator
Material/Parts
Special Environmental Conditions
International Compound
None
#2 or equivalent
Personnel Required
General Safety Instructions
2
None
3-2867
|
||
|
||
