| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-7
3-171.4. Cylinder liner - maintenance instructions (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (Cont)
c.
Cylinder-
1.
Measure the distance
liner
from the top of liner
to top of block with
a dial indicator.
The liner flange must
be .045 to .050 inch
(.1143 to .1270 cm)
below the surface of
the block. However,
even though all of
the liners are within
these specifications,
there must not be over
.002 inch (.0051 cm)
difference in depth
between any two ad-
jacent liners when
measured along the
cylinder longitudinal
center line.
NOTE
A .002 inch (.0051 cm) thick shim is available for
adjusting the liner height. The shim must be installed
underneath the liner insert. Do not cut the shim for
installation. Liner inserts which are .0015 inch
(.0038 cm) thicker or thinner than standard are also
available for service.
2. Matchmark the liner
and cylinder block
with chalk or paint
so the liner may be
reinstalled in the
same position in the
same block bore. The
matchmarks should be
on the side opposite
the camshaft.
d. Holddown
Remove.
clamp
and
cylinder
liner
3-2974
|
||
|
||
