| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-8
4-5. GENERAL (Continued).
Table 4-18. Washer/Dryer Troubleshooting (Continued.)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2. Snubber operation faulty - water or foreign matter on snubber surfaces.
Dry and clean snubbing surfaces and snubber ring. If oil or grease is present,
clean with a high grade of lighter fluid. Locate source of water or foreign matter
and correct.
4.
Motor will not operate.
Step 1. Motor leads off, loose, broken in connector or inside motor.
Disconnect plug connector at motor.
Step 2. Defective motor.
Disconnect plug connector at motor.
Step 3. Timer switch contacts inoperative.
See timer test.
5.
Won't agitate - motor operating.
Step 1. Driver slipping on motor shaft.
Check for driver secure on motor shaft. Tighten set screws as necessary.
Step 2. Belts not in tension, off.
Check primary and secondary belts for tension.
Adjust if necessary.
Step 3. Pulley binding - not rotating.
Check pulleys for rotation. Repair or replace.
Step 4. Drive brace or cable set off or out of place.
Check drive brace and cable set for reversing motion and tension. Adjust if
necessary.
4-66
|
||
|
||
