| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-8
4-7.10A. ENGINE - MAINTENANCE INSTRUCTIONS (Continued).
ENGINE REASSEMBLY (Cont)
Make sure piston rings are in correct position to
prevent breakage.
e. Cylinder Heads.
(1) Install new head gaskets to cylinders.
(2) Set cylinder heads in place on correct cylinders and loosely install the eight nuts, washers, and
lockwashers. Do not tighten cylinder nut until intake manifold is installed. Torque to 16 foot-pounds (21.7 Nm).
NOTE
The long nuts are installed on the outside studs of
the power takeoff side cylinder head.
f.
Air Shrouds.
Install air shrouds and intake manifolds to engine. Torque to 5 to 6 foot-pounds (6.8 to 8.1 Nm).
Tighten cylinder nuts to 16 foot-pounds (21.7 Nm).
g.
Fan Housing.
Install fan housing to crankcase. Torque to 5 foot-pounds (6.8 Nm).
h. Stator Assembly.
Insert electrical leads through grommet in crankcase and reinstall stator assembly to crankcase. Align
mark made during disassembly. Torque to 5.5 foot-pounds (7.2 Nm).
i.
Flywheel.
Install fan drive pulley and starter cup to flywheel. Torque to 47 foot-pounds (63.1 Nm). Make sure fan
drive pulley with machined shoulder is towards the flywheel. Install flywheel on crankshaft. Torque to 60 foot-
pounds (81.3 Nm).
j.
Fan Belt.
Install fan belt and check belt tension.
4-402
|
||
|
||
