| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-5. MARINE GEAR MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - REASSEMBLY (Cont)
w. Propeller
1. Check flange run
Use a dial gage.
Flange
out.
(120)
2. Maximum run-out
should be less than
0.004 inch.
x. Output
1. Check end play.
a. Use dial gage.
shaft
(129)
b. See step 27.
2. End play should be
between 0.003-0.008
inch .
3. Change shims (123)
as required.
y. Reverse
Place on arbor press
driving
hub end up.
gear
(104)
z. Reverse
Press onto gear (104).
The snap ring
driving
groove in the
gear ball
bearing must be
bearing
at the upper end
39
of the bearing.
5-123
|
||
|
||
