OVERHAUL-REASSEMBLY (Cont) - TM-55-1905-220-14-100207

Custom Search

OVERHAUL-REASSEMBLY (Cont)

TM-55-1905-220-14-10 Landing Craft Utility LCU 1671-1679 NSN 1905-01-009-1056 Manual

OVERHAUL-REASSEMBLY (Cont)

TM 55-1905-220-14-10

5-7. VARIABLE SPEED MECHANICAL GOVERNER-MAINTENANCE INSTRUCTIONS (Continued).

LOCATION

ITEM

ACTION

REMARKS

OVERHAUL-REASSEMBLY (Cont)

p. Connecting

1. Install.

link (68),

plain

2. Place the opposite

washer

end of the connecting

(67), and

link on top of the

spring

control link operating

retainer

lever and install the

(66)

connecting pin.

9. Governor

weight

and shaft

assembly

NOTE

If the governor weight carrier assembly was removed from the weight shaft, the

weights must be removed from the carrier before attempting to install the carrier

on the shaft.

a. Weight

1. Support the weight

carrier

carrier (rear face up)

(60)

on a sleeve and a

steel support (with a

1" hole) over an open-

ing in the bed of an

arbor press.

2. Lubricate the weight

shaft with engine oil.

Then, insert the non-

spliced end of the

shaft through the

carrier, sleeve, and

hole in the steel

support. Bring the

ram of the press

down on the shaft

and press the shaft

straight into the

carrier until the

shoulder on the shaft

is tight against the

carrier.

5-202