| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNOR - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - REASSEMBLY (Cont)
i.
Variable
1. Install.
speed
spring
2. Make sure the end of
housing
the spring is over the
(21),
end of the spring
screws
plunger (29).
(19), and
3. Tighten screws to
(20)
13-17 lb-ft (17.6-23.0
Nm) torque.
12. Governor
a. Cover and
1. Place the cover, inner
cover
face down, on two steel
(17)
supports on the bed of
an arbor press as shown
below.
2. Refer to "NOTE" under
"Inspection"; then,
Iubricate the new
needle bearing with
engine oil and start
the bearing, numbered
end up, straight in
the bearing bore in
the cover boss.
5-218
|
||
|
||
