| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-8. BLOWER-MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-ASSEMBLY (Cont)
2. Install the pipe plug
in the vertical oil
passage at the top of
the end plate.
d. Dowel pins
Check the dowel pins.
(66 and
The dowel pins must
67)
project .380" from the
flat inner face of the
front end plate to
assure proper alignment
of the end plate with
the housing.
e. Blower
1. Place the blower
housing
housing on a bench
(61) and
with the top side of
front end
the housing up and
plate (58)
the front end of the
housing facing the
outside of the bench.
2. Position the end
plate (58) in front
of the blower hous-
ing with the top side
of the end plate
facing up. Then,
start the dowel pins
straight into the
dowel pin holes in
the housing. Push
or tap the end
plate against the
housing.
NOTE
Gaskets are not used between the end plates and the housing; therefore, the mating
surfaces must be perfectly flat and smooth.
5-240
|
||
|
||
