| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-34. GOVERNOR - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY (Cont)
Wear eye protection when using compressed air.
3. Hydraulic
a. After the governor drive has been disassembled, wash
drive
all parts in clean fuel oil and dry them with com-
pressed air.
b. Examine gear teeth of drive and driven shafts for
chipping or scoring and, if either of these condi-
tions exist, replace shafts.
c. Revolve bearings by hand to check for excessive wear,
bind, or rough spots. If any of these conditions
exist, install new bearings.
d. Slight end play is not objectionable in single row
annular ball bearings, since they are built with
that characteristic.
e. If inspection reveals the bearings are in good con-
dition, lubricate them with clean engine oil prior
to using.
f.
If inspection reveals defects:
(1) Horizon-
(a) Rest bearing on
tal drive
bed of arbor press.
shaft (7),
and bear-
(b) Press shaft from
Use a brass
ing (8)
bearing.
rod between
ram of press
and shaft.
(2) Driven
(a) Rest bearing on bed
shaft
of arbor press.
assembly
(9) con-
(b) Press shaft from
Use a brass
sisting of
bearing.
rod between
the follow-
ram of press
ing: shaft
and shaft.
sleeve (10),
bearing
(11), and
driven
shaft (12)
5-554
|
||
|
||
