| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-35. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - DISASSEMBLY (Cont)
m. Rotors
Remove from blower
(48 and
housing (50).
49)
n. Bearings
1. Inspect the oil seals.
(51 and
seals. If the seals
52), and
are scored, charred
seals
or hardened so that
(53 and
a tight seal around
54)
the shafts is im-
possible, new seals
should be installed.
If necessary, the
seals may be re-
moved from the end
plates at the same
time the individual,
bearings are removed.
2. Support the outer
face of the end plate
on wood blocks on the
bed of an arbor press.
3. Place the long end of
the oil seal remover
an d installer J6270-3
down through the oil
seal and into the
bearing, with the
opposite end of the
remover under the ram
of the press. Then,
press the bearing and
oil seal out of the
end plate.
4. Remove the remaining
bearings and oil seals
from the end plates in
the same manner.
o. Dowel pins
Remove.
If necessary.
(55)
5-568
|
||
|
||
