| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-64. SLACK PULLER AND MOTOR - ANCHOR WINCH - MAINTENANCE
INSTRUCTIONS (Cont).
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP:
Test Equipment
References
NONE
NONE
Equipment
Special Tools
Condition Condition Description
Bearing puller
NONE
Ring compressor
Torque wrench
Material/Parts
Special Environmental Conditions
Grease MIL-G-81322 type GH
Do not drain oil into bilges. Use
Lubricating oil MIL-L-2105
the oil/water separation/recovery
type G090
system to collect used oil.
Hydraulic "O" ring and seal
kit P/N 514-18564 or
Overhaul kit P/N 514-08889
Personnel Required
General Safety Instructions
2
Observe WARNINGS in this procedure.
(5-776 blank)/5-777
|
||
|
||
