| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-65.2. DISCONNECT CLUTCH ASSEMBLY - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
INSPECTION
2.
a. All
Clean thoroughly.
parts
b. Springs
Check for color
Color yellow
(18)
and weight/height.
Weight/height
minimum 170 lbs.
@ 2 1/4 inches.
c. Pressure
Inspected for warp,
plate
heat checks, and score
(21)
marks on the friction
surface as well as the
condition of the driv-
ing slots and pin holes.
If excessive wear at the-
driving slots or elonga-
tion of the pin holes is
present, the pressure
plate should be replaced.
d. Flywheel
Inspect for wear of the
ring (6)
driving lugs and cover
pin holes. The cover
should fit freely in
the slots of the pres-
sure plate with approx-
imately .006 inch
clearance between the
lugs, and mating slots
in the pressure plate.
The cover should be
checked for distortion
by placing it with the
flange face down on
the surface plate.
Replace if distorted.
e. Toggle
Inspect. If any elonga-
link
tion in the holes is
(12)
shown, replace.
f.
Pins
Inspect and replace if
(all)
worn.
5-832
|
||
|
||
