| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-65.2. DISCONNECT CLUTCH ASSEMBLY - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
RECONDITIONING
3. Pressure plate
It is recommended that not more than 1/32 inch be machined from the pressure plate
friction surface. If more than this amount or any portion thereof is removed, clutch
should be reassembled using hole "A" of toggle link. IMPORTANT: when machining
amounts in excess of .0312 inch it is absolutely essential that the resurfaced dimension
"B" 1.470 inch be obtained and clutch be reassembled using hole "B" of toggle link.
"Dimension B" is the dimension from the top of the-pin to the friction surface of the
pressure plate as shown below. It is important that these instructions be followed,
otherwise short clutch life or incomplete clutch release (drag) will result.
5-838
|
||
|
||
