| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-65.2. DISCONNECT CLUTCH ASSEMBLY - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
e.
ALTERNATE METHOD. An arbor or drill
press may be used to compress the springs
if preferred. Place block across the top of
the spring retainer for this operation. Install
two 3/8 inch x 16 x 3 inches hold-down
screws opposite one another through the
holes in the spring retainer and thread into
aligning tapped holes in the pressure plate
provided for this purpose to hold the springs
fully compressed.
NOTE
Screws 3/8 inch by 16 x 5 1/2 inches long may be left in place
until after the clutch in installed in the engine flywheel, or two
standard 3/8 inch by 16 x 3 inch bolts installed at right angles to
5 1/2 inch screws to hold the springs compressed, and remove
long screws. IMPORTANT: The 5 1/2 inch screws or hold-down
screws must remain in place until the clutch has been bolted into
the engine flywheel.
5-842
|
||
|
||
