| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-65.2. DISCONNECT CLUTCH ASSEMBLY - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
g. Link
The proper link hole to use
(12)
will depend on whether or
not the pressure plate has
been refaced. Toggle link
hole "A" is assembled to
the pressure plate if new
pressure plate is used.
Hole "B" is assembled only
if the pressure plate has
been refaced.
h. Release
Assemble sub-assembly
lever
consisting of lever and
(13),
link to the pressure
and
plate by placing toggle
link
link in milled slot of
(12),
pressure plate and in-
assem-
serting pressure plate
bled
pin as shown. Drive
pins
the pin in far enough
(11),
so cotter pins can be
and
inserted.
cotter
pins (8)
i.
Driving
1. The driving pins
pins
should be installed
(22),
in the engine flywheel
and
(press fit), and
inter-
squarely aligned with
mediate
the friction face of
plate
the flywheel. Place
(24)
a machinist square
firmly against rim
of the flywheel and
make sure the contact
face of the driving
pins have even contact
with the square.
5-844
|
||
|
||
