| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-65.2. DISCONNECT CLUTCH ASSEMBLY - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
l.
Fly-
With the four release
wheel
levers (13) in position
(25)
so that studs (20) in
the spring retainer are
entered in the milled
slots in the underside
of the levers, place the
flywheel ring (cover) (6)
into position, aligning
the lugs in the underside
of the cover with the
mating slots in the
pressure plate. Be sure,
if original pressure
plate is used, that the
cover registers with the
aligning "O" mark stamped
on the outside diameter
of both the cover and
the pressure plate.
m. Needle
Install in release
lever
(5)
5-848
|
||
|
||
