| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-11
5-75. FLYWHEEL AND HOUSING - MAINTENANCE INSTRUCTIONS.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Test Equipment
References
NONE
NONE
Equipment
Special Tools
Condition Condition Description
Drift
NONE
Hammer
Acetylene torch
Material/Parts
Special Environmental Conditions
NONE
NONE
Personnel Required
General Safety Instructions
1
Observe precautions when using acetylene torch.
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1. Flywheel
Check whether or not the ring gear teeth are
Ring
chamfered. The replacement gear must be
Gear
installed so that the chamfer on the teeth
faces the same direction with relationship to
the flywheel as on the gear that is to be
removed. Then remove the ring gear as follows:
a. Support the flywheel, crankshaft side down,
on a solid flat surface or hardwood block
which is slightly smaller than the inside
diameter of the ring gear.
b. Drive the ring gear off the flywheel with a
suitable drift and hammer. Work around the
circumference of the gear to avoid binding
the gear on the flywheel.
5-1055
|
||
|
||
