| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-11
5-143. COMPRESSOR-HVAC-MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL (Cont)
Never operate a compressor with a valve plate off unless cylinder sleeves are fastened
in place. Cylinder sleeves can be held in place by capscrews and washers. Screw
capscrews into tapped holes normally used to hold valve plate in place. Use plate
washers large enough to extend well over faces of both sleeves or make up steel plates
for this purpose. Two washers or plates should be used on each cylinder deck.
NOTE
Whenever a cylinder sleeve or valve plate is replaced, the suction valve disc
should also be replaced, or turned over if reverse side is unused.
1.
Discharge
Replace.
Refer to step 7.
valve
5-1500
|
||
|
||
