| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-11
6-6. ELASTOMERIC COMPENSATING WINCH - MAINTENANCE INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY (Cont)
e. Screws (9)
Remove.
f.
Bearing (6)
Remove.
g. Inner mounting
Remove.
plate (5)
h. Dowels (8).
Remove
Use new dowels
for reassembly.
i.
Tortional
Remove.
Spring (4)
j.
Cogs (3)
Remove.
k.
Shim(s) (2)
Remove.
l.
Drum weldment
Reverse drum to place
(1)
small diameter in the up
position.
m. Screws (12)
Remove.
n. Outer mounting
Remove.
plate (11)
INSPECTION
2. a. Inspect the tortional spring for cracks, cuts, or voids in the elastomer on both inside and outside diameters. If any
are detected that measure longer than one inch or with depths greater than .25 inch notify a technical representative for
corrective action.
b. Inspect the cogs for gouges or worn surfaces. Gouges greater than .015 inch deep x .12 inch long and worn
surface greater than .25 inch x .25 inch shall be cause for replacement.
Change 1 6-33
|
||
|
||
