| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-2
2-54.1 ADJUSTING UPWARD COMPENSATION - REMOTE.
a. For full upward compensation, push the "LOWER" control until slack is visible in the ramp chain.
b. Push the "RAISE" control until the slack is out of the ramp chain and the ramp is riding on the chain.
2-54.2 ADJUSTING DOWNWARD COMPENSATION - REMOTE.
a. For full downward compensation, push the "LOWER" control until the ramp chain is slack.
b. Push the "RAISE" control until the slack is eliminated. (The ramp should not be riding on the chain.)
2-55.
RAISING BOW RAMP - REMOTE.
Remote operation from the pilothouse. To operate the winch and raise the bow ramp, proceed as follows:
Do not enter or attempt to move around in the winch compartment with the winch running.
There is always danger of becoming entangled in the wire rope.
Never enter the winch compartment alone.
Whenever working on the ramp gate, the wire rope, or in the vicinity of the winch in the winch
room, the power to the winch must be disconnected.
Keep clear while winch is in operation.
NOTE
Both generators should be operating in parallel.
a. Pilothouse.
(1) Press the RAISE push-button control (1) until the ramp is against the gasket stop.
(2) Release button to stop ramp.
(3) Replace dogs on ramp and latch securely (see Illustration page 2-429).
(4) Push the "LOWER" control (2) until the ramp chain and cable are slack. The slack cable switch may shut off
the motor.
(5) Release button to stop ramp.
Change 4
2-431
|
||
|
||
