| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-4
3-34. CYLINDER HEAD - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
REMOVAL (Cont)
b. Water
Remove.
Refer to para-
mani-
fold
11. Injector
Injector
Remove.
Remove as an
control
control
assembly.
tube and
tube and
Refer to para-
brackets
brackets
NOTE
If the cylinder head is to be disassembled for
reconditioning of the exhaust valves and valve
seat inserts or for a complete overhaul, remove
fuel pipes and injectors at this time. See
NOTE
Check the torque on the cylinder head bolts and
stud nuts (if used) before removing the head. Then
remove the bolts and nuts and lift the cylinder
head from the cylinder block. If interference is
encountered between the rear end of the right-bank
cylinder head and any of the flywheel attaching
bolts, loosen the bolts. Checking the torque
before removing the head bolts and examining the
condition of the compression gaskets and seals
after the head is removed may reveal the causes
of any cylinder head problems.
CAUTION
When placing the cylinder head assembly on a bench,
protect the cam followers and injector spray tips,
if the injectors were not removed, by resting the
valve side of the head on 2 inch (5.08 cm) wood
blocks.
3-734
|
||
|
||
