| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-4
3-40.4. CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
all of the liners are
within these specifi-
cations, there must
not be over .002 inch
(.0051 cm) difference
in depth between any.
two adjacent liners
when measured along
the cylinder longitu-
dinal center line.
NOTE
A .002 inch (.0051 cm) thick shim is available for adjusting the liner height. The
shim must be in-stalled underneath the liner insert. Do not cut the shim for
installation. Liner inserts which are .0015 inch (.0038 cm) thicker or thinner than
standard are also available for service.
2. Matchmark the liner
and the cylinder block
with chalk or paint so
the liner may be rein-
stalled in the same
position in the same
block bore. The
matchmarks should be
on the side opposite
the camshaft.
d. Hold
Remove.
down
clamp
and
cylinder
liner
3-864
|
||
|
||
