| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-4
3-40.4. CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
c. Piston
Push or pull the piston
and con-
and connecting rod into
necting
the liner until the upper
rod (2)
bearing shell is firmly
seated on the crankshaft
journal.
CAUTION
The distance from the vertical center line of the connecting rod bolts to the edges
of the rod are not equal. Therefore, when installing the piston and connecting rod
assembly, be sure that the narrow side of the two connecting rods on the crank-
shaft journal are together to avoid cocking of the rod.
d. Lower
Assemble and lubricate.
The lower bear-
bearing
ing shell has a
shell (4)
continuous oil
and bear-
groove from one
ing cap
parting line to
(5)
the other. Lu-
bricate the
bearing shell
with clean en-
gine oil.
e. Bearing
Install the bearing cap
Tighten the
cap with
and the bearing shell on
connecting rod
bearing
the connecting rod with
bolt nuts to
shell,
the identification num-
60-70 lb-ft
connec-
bers on the cap and the
(81-95 Nm)
ting rod
rod adjacent to each
torque (notch
(2) and
other.
or imbedded "O"
nuts (6)
lubrite nut) or
65-75 lb-ft
(88-102 Nm)
torque (castel-
lated nut).
3-870
|
||
|
||
