| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-5
3-96.4. CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
a. Upper
Install in connecting rod
The upper bear-
bearing
(2). Lubricate.
ing shell does
shell (1)
not have a con-
tinuous oil
groove. Lubri-
cate the bear-
ing shell with
clean engine
oil.
NOTE
Each connecting rod and its cap is numbered on
one side - IL, IR, 2L, 2R, etc. These numbers and
letters identify the caps with the rods and indicate
the particular cylinder in which they are used.
Maintain these positions when assembling the
engine.
b. Piston,
1. Position the piston,
rod and
rod and liner assem-
liner
bly in front of the
assembly
cylinder block bore
(3)
so the identification
number and letter on
the rod face the outer
edge of the cylinder
block and the match-
marks on the liner and
the block are in
alignment.
2. Guide the end of the
connecting rod through
the block bore care-
fully to avoid damag-
ing or dislodging the
bearing shell.
3. Slide the piston, rod
and liner assembly
straight into the
block bore until the
liner flange rests
against the insert in
the counter bore in the
block.
3-1688
|
||
|
||
