| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-139.1. HYDRAULIC PUMP - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
c. Pre-
Install in shaft end
formed
cover (16).
packing
(36)
d. Shaft
1. Clamp in a vise and
end
tighten jaws so they
cover
clamp the cover about
(16)
1/4 inch (3.65 cm) below
the ten hole face.
2. Store the face, and
air blow or wipe clean.
e. Roller
Insert.
Use an arbor
bearing
press.
(35)
f. Thrust
1. Store the face which
plate
will be closest to gears.
(31)
2. Air blow or wipe clean.
3. Place a small amount
of grease into the
middle slot in the
thrust plate.
g. Pocket
Place a 29/64 inch
Use pocket seal
seal
(1.1509 cm) long pocket
K3026-4. Be
(34)
seal into the middle
sure seal is
slot.
cut straight
across and is
same length as
the slot.
h. Thrust
Assemble.
1. Tap together
plate
with inserted
(31),
pocket shield
and
(34) over the
shaft
bearing races
end
in shaft end
cover
cover with soft
(16)
hammer.
3-2300
|
||
|
||
