| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-162. FUEL INJECTOR CONTROLS - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
ADJUSTMENT
6.
Load
a.
Nut
Loosen and remove adjust-
limit
(21)
ing screw (20).
device
b.
Screw
Loosen screw so arm (17)
(15)
is free to turn on the
injector control tube (19).
c.
Screw
Adjust so bottom of nut
This is an
(20),
is 1-3/4 inch (4.45 cm)
initial set-
and nut
from bottom of screw.
ting.
(21)
d.
Screw
Screw the screw into
(20),
plate until nut (21)
and
bottoms against top
plate
of the plate.
(8)
e.
Injector
1. Hold in full-fuel
Check that con-
rack
position.
trol tube will
control
go into the
tube
full-fuel
(19)
position. Re-
adjust arm if
necessary.
2. Place arm (17) against
bottom of screw (20).
3. Tighten screw (15).
f.
Screw
1. Hold screw to keep it
(20),
from turning. Set nut
and
until the distance be-
nut
tween bottom of nut and
(21)
top of plate corresponds
to the dimension (or num-
ber of turns) stamped on
the plate. Each full
turn of the screw equals
.
007 inch (.018 cm) or
.
042 inch (.107 cm) for
each flat on hexagon head.
3-2672
|
||
|
||
