| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-164.1. CYLINDER HEAD - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
29.
Cylinder
head
(2)
NOTE
Make a final visual check of the compression gaskets and seals to
ensure that they are in place before the cylinder head is lowered. This
is a very important check. Gaskets and seals which are not seated
properly will cause leaks and "blow-by" and result in poor engine
performance and damage to the engine.
1. Apply a small amount
of International Com-
pound No.2, or equiva-
lent, to threads and
underside of the head
of all cylinder head
attaching bolts (1).
2. Wipe the bottom of the
head clean. Lower the
head over the guide
studs.
3. Install a bolt thru
each piloting sleeve
at the corners of the
head and thread them
finger tight into the
cylinder block. Con-
tinue to tighten these
bolts (fingertight) as
the head is lowered
into position on the
cylinder block.
NOTE
Cylinder head bolts are especially designed for this
purpose and must not be replaced by ordinary bolts.
3-2716
|
||
|
||
