| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-166.3.
IDLER GEAR AND BEARING ASSEMBLY - MAINTENANCE INSTRUCTIONS
(Continued).
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
4. Place second bearing
cone, numbered side
up, in idler gear and
bearing cup assembly,
and against spacer
ring.
5. Then, position the
idler gear hub over
the bearing cones
so that the oil hole
in the hub is 180
from the gap in the
spacer ring.
b. Hub
Press the hub into
(10)
the idler gear bearing
cones, while rotating
the gear (to seat
rollers properly be-
tween cones) until
the face of the hub
which will be adjacent
to the cylinder block
end plate is flush
with the corresponding
face of the bearing
cone. The bearing
cones should be sup-
ported so as not to
load the bearing
rollers during this
operation.
3-2806
|
||
|
||
