Custom Search
 
  
 
TM 55-1905-220-14-6
3-166.4. CRANKSHAFT TIMING GEAR - MAINTENANCE INSTRUCTIONS.
a.  The crankshaft timing gear is bolted to the flange at the rear end of the crankshaft and drives the
balance shaft gear through an idler gear.
b.  Since the camshaft must be in time with the crankshaft, timing marks are located on two teeth of the
idler gear with corresponding timing marks stamped on the crankshaft gear and camshaft and balance shaft
gears (refer to paragraph 3-166.2).
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP
Test Equipment
References
None
None
Equipment
Special Tools
Condition
Condition Description
None
Flywheel Housing Removal
Material/Parts
Special Environmental Conditions
None
None
Personnel Required
General Safety Instructions
1
Observe WARNING in procedure
LOCATION
ITEM
ACTION
REMARKS
NOTE
The flywheel housing and flywheel must be removed
to perform the following maintenance instructions.
3-2815


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business