| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-167.1. FLYWHEEL - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (Cont)
b. Although the flywheel
seldom requires re-
placement, the fly-
wheel ring gear may
become worn due to
normal usage or dam-
aged by improper use
of the starting motor
to the extent that
it must be replaced.
If replacement of
the ring gear is
necessary, refer to
Direct Support Mainte-
nance.
INSTALLATION
3.
a.
Dowel
Check the extensions.
The dowels must
pins
not extend more
(4)
than 1/2 inch
(1.27 cm) from
the crankshaft.
b.
Flywheel
1. Attach flywheel lifting
(3)
tool J6361-01 to the
flywheel with two 7/16
inch-14 bolts. Then,
using a chain hoist,
position the flywheel
in the flywheel housing
and over the dowels in
the crankshaft.
NOTE
Since one bolt hole is offset, the flywheel can be
installed in only one position.
2. Remove the flywheel
lifting tool.
3-2834
|
||
|
||
