| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-6
3-167.2. FLYWHEEL - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSPECTION
3.
Flywheel
Clean and inspect
housing
for cracks and
(15)
other damage.
INSTALLATION
4.
Engine
a.
Gear
Lubricate the teeth
rear
train
with clean engine oil.
plate
b.
Gasket
Attach to end plate.
(16)
c.
Oil
Coat the lip of the
Replace if
seal
seal with engine oil.
necessary.
Refer to para-
d.
Pilot
Install if necessary.
graph 3-166.
studs
5.
Flywheel
a. Flywheel
1. Lift with chain
housing
housing
hoist.
(15)
2.
Position housing
over crankshaft
and up against
the cylinder
block rear end
plate and gasket.
b.
Six
Install in positions
Bolts are 3/8-
bolts
1 thru 6 (Idler gear
16. Tighten
(5),
hub and idler gear
finger tight.
and
hole spacer).
flat-
washers
(6)
NOTE
When tightening the idler gear hub bolts, turn the
crankshaft to prevent any bind or brinelling of the
idler gear bearing. The crankshaft must be rotated
for the flywheel housing bell tightening also.
3-2842
|
||
|
||
