| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-7
3-171.4. CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
c. Cylinder
1. Measure the distance
liner
from the top of liner
to top of block with
a dial indicator.
The liner flange must
be .045 to .050 inch
(.1143 to .1270 cm)
below the surface of
the block. However,
even though all of
the liners are within
these specifications,
there must not be over
.002 inch (.0051 cm)
difference in depth
between any two ad-
jacent liners when
measured along the
cylinder longitudinal
center line.
NOTE
A .002 inch (.0051 cm) thick shim is available for adjusting the
liner height. The shim must be installed underneath the liner
insert. Do not cut the shim for installation. Liner inserts which
are .0015 inch (.0038 cm) thicker or thinner than standard are
also available for service.
2. Matchmark the liner
and cylinder block
with chalk or paint
so the liner may be
reinstalled in the
same position in the
same block bore. The
matchmarks should be
on the side opposite
the camshaft.
d. Holddown
Remove.
clamp
and
cylinder
liner
3-2938
|
||
|
||
