| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-24.
IDLER GEAR.(Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
b. With the timing marks in
alignment, start the idler
gear in mesh with the crank-
shaft gear and camshaft gear,
and simultaneously rotate the
gear so the hollow pin in the
hub registers with the oil
hole in the end plate.
c.
Roll the idler gear into
position and align the hollow
pin with the hole in the end
plate. Then, gently tap the
hub until it seats against
the end plate.
d. Install screw (1), and flat-
washer (2) after making sure
the hub (7) is tight against
the end plate. Tighten screw
to 80-90 lb-ft (108.5-122.0
Nm) torque.
6-389
|
||
|
||
