| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-27.2. CONNECTING ROD - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION/ITEM
ACTION
REMARKS
REMOVAL (Cont)
b. Remove oil inlet pipe.
Refer to para-
graph 6-26.3.
c.
Remove lube oil pump.
Refer to para-
graph 6-26.1.
d. Remove cylinder head.
Refer to para-
graph 5-15.
2. Connecting
Rod(s)
NOTE
The connecting rod bearing caps are numbered 1, 2, etc., with matching numbers
stamped on the connecting rods. When removed, each bearing cap and the
bearing shells must always be reinstalled on the original connecting rod.
a. Remove nuts (1).
b. Remove bearing cap (2).
c.
Push connecting rod (3) and
piston assembly up into the
cylinder liner.
d. Remove bolts (4).
e. Remove upper bearing shell
Do not pound on
(5) from connecting rod.
edge of bearing
shell with sharp
tool.
f.
Remove lower bearing shell
Do not pound on
(6), if necessary.
edge of bearing
shell with sharp
tool.
g. Disassemble piston.
Refer to para-
graph 6-27.1.
6-440
|
||
|
||
