| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-27.4.
CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
NOTE
A .002 inch (.0051 cm) thick shim is available for adjusting the liner height. The shim
must be installed underneath the liner insert. Do not cut the shim for installation. Liner
inserts which are .0015 inch (.0038 cm) thicker or thinner than standard are also
available for service.
d. Matchmark the liner and the
cylinder block with chalk or
paint so the liner may be
reinstalled in the same
position in the same block
bore. The matchmarks should
be on the side opposite the
camshaft.
e. Remove hold down clamp and
cylinder liner.
NOTE
Do not remove the liner insert.
7. Piston and
a. Lubricate piston, rings, and
Use tool J3272-
Connecting Rod
inside surface of ring com-
01. Use lubri-
Assembly
pressor.
cant cindol 1705
oil
NOTE
Inspect the ring compressor for nicks or burrs, especially at the non-tapered inside
diameter end. Nicks or burrs on the inside diameter of the compressor will result in
damage to the piston rings.
b. Place compressor on wood
block with chamfered end up.
6-476
|
||
|
||
