| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-27.4.
CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
e. Note the position of the
matchmark and place the
cylinder liner, with the
flange end down, on the wood
block.
f.
Place the ring compressor and
the piston and connecting rod
assembly on the liner so the
numbers on the rod and cap
are aligned with the match-
mark on the liner.
NOTE
The numbers on the side of the connecting rod and cap identify the rod with the cap and
indicate the particular cylinder in which they are used. If a new service connecting rod is
to be installed, the same identification numbers must be stamped in the same location
as on the connecting rod that was replaced.
g. Push the piston and connec-
ting rod assembly down into
the liner until the piston is
free of the ring compressor.
CAUTION
Do not force the piston into the liner. The peripheral abutment type expanders apply
consider- ably more force on the oil ring than the standard expander. Therefore, extra
care must be taken during the loading operation to prevent ring break- age.
h. Remove connecting rod cap and
ring compressor. Push piston
down until the compression
rings pass the cylinder liner
ports.
6-478
|
||
|
||
