| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-27.4.
CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
d. Assemble lower bearing shell
(4) and bearing cap (5) and
lubricate. The lower bearing
shell has a continuous oil
groove from one parting line
to the other. Lubricate the
bearing shell with clean
engine oil.
e. Bearing cap with bearing
shell, connecting rod (2),
nuts (6), and bolts (1)
install the bearing cap and
the bearing shell on the
connecting rod with the
identification numbers on
the cap and the rod adjacent
to each other. Tighten the
connecting rod bolt nuts to
60-70 lb-ft (81-95 Nm)
torque (notch or imbedded
"0" lubrite nut) to 65-75
lb-ft (88-102 Nm) torque
(castellated nut).
f.
Check the connecting rod (2)
side clearance. The clear-
ance between each pair of
connecting rods should be
.006 to .012 inch (0.015 to
0.030 cm) with new parts.
NOTE
Install the remaining liner, piston and rod assemblies in the same manner. Use hold-
down clamps to hold each liner in place.
After all of the liners and pistons have been installed, remove the hold-down clamps.
6-482
|
||
|
||
