| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-37. POWER TAKE-OFF ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
ADJUSTMENT
14. Clutch
a. To check the end play in the clutch
Drive
drive shaft bearing, the power
Shaft
take-off must be removed from the
Bearing
engine and the clutch assembly
End Play
removed from the drive shaft to be
checked correctly. If the clutch
drive shaft and bearing assembly
has just been installed in the
clutch housing, the end play in
the drive shaft bearing must be
checked before the clutch is
attached to the drive shaft.
b. Servicing personnel should read
the instructions on the clutch
housing name plate. Instructions
on the name plate are correct for
the particular power take-off to
which they are attached. If an
occasion occurs that a unit does
not have the clutch drive shaft
end play listed on the clutch
housing name plate, the bearing
should be adjusted in accordance
with the recommendations listed
in the table below.
Clutch Sizes
End Play
8"
.004 to .006"
6-772
|
||
|
||
