| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-37. POWER TAKE-OFF ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
ADJUSTMENT (Cont)
b. When the clutch is properly
adjusted, heavy pressure is
required at the outer end of
the hand lever to move the
throwout linkage to the "over
center" or locked position.
c. Adjust clutches as follows:
(1)
Disengage the clutch,
with the hand lever.
(2)
Remove the inspection
hole cover to expose the
clutch adjusting ring.
(3)
Rotate the clutch, if
necessary, to bring the
clutch adjusting ring lock
within reach.
(4)
Remove the clutch adjust-
ing ring spring lock screw
and lock from the inner
clutch pressure plate and
adjusting ring. Then,
while holding the clutch
drive shaft to prevent
the clutch from turning,
turn the clutch adjusting
ring counterclockwise and
tighten the clutch until
40 to 55 lbs (18.1-24.9
kg) pressure on the outer
end of the hand lever,
at the clutch release
shaft is obtained. Then,
reinstall the clutch
adjusting ring spring
lock, making sure the
ends of the lock are in
the notches in the adjust-
ing ring.
6-785
|
||
|
||
